UPS PROTEX

Line Interactive Pseudosinuvoidali from 700 to 2000 VA
The PROTEX UPS are single-phase UPS to pseudo-sinusoidal wave designed to power and protect IT equipment such as computers, monitors, printers, routers, switches, modems, etc .: for they provide supply, regulated and filtered by AVR ( electronic stabilizer) and in case of failure of the main power grid, the UPS circuits shall generate, via its internal batteries, an AC current at 230 Vac 50 Hz.
UPS PROTEX USB LCD in addition to what mentioned above, are equipped with LCD digital display that communicates in real time to the user, the main electrical measurements used, or input and output voltage, output load, and status of the internal batteries.

Have a 'USB interface that can be used to signal to a computer network and the conditions of absence of the end of autonomy, which makes possible the performance of automatic data saving functions during a prolonged blackout with all popular operating systems (Windows, Linux, Novell, etc.). The UPS can also communicate the various measurements recorded (input voltage, output and battery, consumption, frequency), and can also be programmed to turn on and turn off automatically at user-defined times.

The Protex UPS comply with the latest RoHS and are covered by a 2 year warranty.
Operating in the presence network mode:
When the UPS is working normally, with this network input, the output voltage 230 Vac 50 Hz is filtered (input filter), stabilized by AVR (automatic digital image stabilization), filtered again (output filter) and then It goes to feed the connected loads.
While the battery is low:
This is controlled and monitored; when the battery voltage falls below the set limit, the UPS switches off automatically protects the batteries from excessive discharge.
Operating in battery mode:
When there is no input mains, the UPS instantly switches to battery mode, where the internal batteries supply power to the inverter, which delivers an output voltage 230 Vac 50 Hz, filtered (output filter) and stabilized, to continue to power the connected loads.
When the voltage returns:
If the UPS work in battery mode, the microprocessor of the system, after the verification of the quality of the input voltage, it performs switching in the presence network mode. If the UPS was turned off because the battery had run out, then it starts up again automatically (Auto Switching) function.