Quest Pro DETEKNIX

Quest Pro DETEKNIX

The Metal Detector Quest Pro is a detector suitable for all types of research. The working frequency is 13 kHz.
Included accessories: Wireless Headphones, knife Dig Deteknix, Deteknix Cap and Transport Exchange.
The metal detector Deteknix Quest Pro is a detector suitable for all types of terrain. This is not a diver model but the plate may still be immersed in water as it turns out to be completely watertight.

The Quest Pro has a 13 kHz frequency VLF (Very Low Frequency). The structure is formed by two rods that allow to use the detector to variable lengths ranging from a minimum of 80 cm until arriving to a maximum of 130 cm. The audio tones are 6 and vary depending on the object identified. This comes with the Pro Pinpointer.

The battery can also be recharged via USB

One of the strengths of this metal detector is certainly the battery. Here we are not using the classic batteries but an internal battery with 2000 mAh Li-Po type. The battery allows the researcher to brush for a full 30 hours if it is used for audio classic speaker. The battery charge lasts about 20 hours if instead for listening to sounds will use the wireless headphones. The battery can be easily recharged not only through the normal power line but also using a USB cable. This will enable more technological researchers to recharge their metal detector Deteknix Quest Pro also through a USB port of a PC or any other device that has such technology.
The search plate Quest Pro is a 9 × Wide Scan TurboD Waterproof Coil 11 "(measured in inches) corresponding to 22.5 × 28 cm. The plate can also be immersed in water, sweet and salty, sealed tightly.
The Quest Pro can work both in research All Metal, if you want to look for any metal, which in Discrimination mode, if you want to delete one or more types of metal from their research. For those who want to use a preset program already exist 5 different programs that will allow to satisfy every need of detectorista.
The display is a backlit LCD type and is large 6 × 7 cm. The display allows you to monitor the battery charge state, the volume settings, the mineralization of the soil and all the different settings dedicated to Mode, Gain, Threshold and Filter Id. The ground balancing can be done either in automatic mode or manual mode.
The display will also show the numerical ID of the identified target. This means that each metal will be allocated a band of numerical and that the researcher, when the metal detector will detect a metal object ID, can understand his already material from the ID number appeared on the screen, in addition to the audio signal.
DATA SHEET
OPERATING FREQUENCY: 13 kHz
TYPE OF RESEARCH: Motion
BALANCE OF THE SOIL: Automatic
BALANCE OF THE SOIL: Manual
SEARCH IN: Discrimination
SEARCH IN: All Metal
SENSITIVITY ADJUSTMENT: Yes
SETTING DISCRIMINATION: Yes 99 detection ID
ADJUSTING THRESHOLD: Yes
PINPOINT: Yes
PROGRAMS PRE-SET: 5
INDICATION TYPE OF METAL DETECT: Yes
INDICATION OF SOIL MINERALISATION: Yes
TONE DETECTION: Yes 6 variables tones
DISPLAY: backlit LCD 60X70mm
PLATE OF SEARCH: 9 × 11 "(22.5x28cm) Wide Scan TurboD Waterproof Coil
INTERNAL SPEAKER: Yes
POWER SUPPLY: Internal Battery 2000mAh Li-Po
AUTONOMY: Approximately 30 hours with audio speakers, about 20 hours with wireless headphones
SIGNAL BATTERY It
HEADPHONES: Yes, Wireless
AUCTIONS DETACHABLE: Yes - 2 shares
LENGTH: 80 - 130cm
WEIGHT: 1,350 kg
2 years warranty