Metal Detector Fortune M3 Case PL2943 Large Display 7×4 Winstar Depth of search up to 2M - IB is a selective metal detector with metal discernment, works on the principleof induction balance.
P PL2943WH - a thin instrumented waterproof case made of impact-resistant heat-resistant ABS plastic UL-94V0.
Provides protection from penetration of dust and moisture according to IP65.
Metal Discrimination- a numerical and bar graph display of the VDI, as in more expensive devices,(various objects and metalalloys corresponds to a digital value).
Multifrequency instrument can be used with the device aredifferent coils with different frequencies.
The ability to mask, to exclude from thesearch for the unwanted metal. For example to exclude iron.
Characteristics:
* Discrimination: the number of VDI, sinograf.
· * Voice of purpose (objectives): 90-tone, 4-tone, 2-tone.
· * Ground Balance:manual, automatic.
· * Setting up ferrite: automatic.
· * Compensationcare balance sensor: automatic.
· * Backlightdisplay.
· * Headphone out
· * Large Display Winstar 7 x 4
· * The latest available firmware.
. * Masks. The ability to mask unwanted metal.
· * Several search algorithms.
· * Pinpointer.
· * Setting thedevice to the frequency of an existing sensor.
· * Frequency coil search sensor: 5-20 kHz
· * Body PL2943WH size 140 х 100 х 30 mm / 5.5 х 4.3 х 1.18 inch
· * Waterproof coil search sensor DD 30*32 cm.
PL2943WH - a thin instrumented waterproof case made of impact-resistant heat-resistant ABS plastic UL-94V0.
Provides protection from penetration of dust and moisture according to IP65.
The main parameters of the assembly:
* Lithium-ion battery 2200 mAh 3.7V;
* Collapsible, adjustable rod, lower part - high-impactplastic, the upper part - high strength aluminum, covered with powder paintfactory;
* Fee-quality, factory-built, two-sided with protectivemask and metallization of holes.
SUPPLY:
1. The complete set unit is powered by a 3.7 V (lithiumbattery 18650 on 2600 mAh).
2. If your power is made, it can be from 2 to 12 V.
3. Power Connector for plug 5,5h 2,1 mm.
4. The transducer frequency: 7.2 kHz (default).
5. The spacing between the TX-RX: 1,7-1,8 kHz.
6. The sensor connector pinout is as follows: RX + / RX - / Screen / TX + / TX -
Detection range detector Fortune M3 in the air:
* DD 320*300 mm 7 kHz / current 86 mA / spacingfrequency of 1.8 kHz / 6 sens's.
* 5 kopecks USSR 1981 (on the coin ) - 410 mm / 16.1 inch
* 3 kopecks 1910 (on the coin) - 370 mm / 14.5 inch
* The average detectionrange of air - 320-570 mm / 12.6 - 22.4 inch
* Large metal objects to 1500-2000 mm / 59 - 78.7 inch (on the coin)