Magnet 130 Kg. G-GTN-60

Magnet 130 Kg. G-GTN-60
Magnet GTN-G-60 steel base and stem with external thread, pull of ca. 130 kg.
Magnet GTN-G-60 steel base and stem with external thread, pull of ca. 130 kg.

Principle: the powerful Neodymium magnets are embedded in a steel base. The base steel increases the strength of the magnet in the case in which the magnet rests on a metal support of a certain thickness. If there is no direct contact with the counterpart metal or if the iron sheet is thin, enamelled or rough, the magnets will have a less far reaching.

Shear stress: the attraction force indicated was measured perpendicular to the contact surface. To move the magnet sideways force is needed much less. Therefore, by using a magnet with a steel base on a wall, you will have a capacity much less than that which would occur using the same magnet on a ceiling.

Rust: These magnets are not stainless and are therefore only suitable for use in indoor environments not exposed to moisture.

Tacnica card:

Article ID GTN-60
• Material NdFeB
• Diameter of the base D 60 mm
• height H1 15 mm
• Total height H2 30 mm
• Thread M M8
• Tolerance +/- 0.1 mm
• Coating Nickel (Ni)
• Steel Q235 (China)
• magnetization N42
• pull of ca. 130 kg
• Maximum operating temperature 80 ° C
• Weight 260 g

DOWNLOADS